How to adjust the running sand belt
Author£ºAdminDate£º2018-4-21View£º5091
There are at least one or more deviation correction mechanisms in the belt conveyor, which mainly prevents the deviation of the belt in the belt conveyor.
In the normal use, the belt machine may cause the belt to run off because of the wear of the moving parts. Or because the long vibration of the equipment leads to the loosening of the bolt, the adjustment of the swing of the belt around the belt can be achieved by adjusting the belt adjustment handwheel.
Pay attention to the abrasive belt machine in the abrasive belt machine to adjust the deviation of the need to reduce the speed of the inverter, the screw screw on the fixed nut loosened, slowly adjust the handwheel, observe the direction of the abrasive belt. By adjusting this handwheel, the adjustment of belt deviation is achieved. When adjusted, fix the nut on the screw bar.
If the above steps are not able to improve the abrasive belt, the wear of the belt correcting wheel should be checked. Need to be replaced when necessary.